[solved] - I think the driver doesn't find the firmware - D-Link wireless card

already solved, i missed this step

http://acx100.sourceforge.net/wiki/Firmware

---------------------------------------------------------

Hello people, i'll try to explain

The steps I made:

Installed the madwifi like says the tutorial from here - http://madwifi.org/wiki/UserDocs/Distro/Debian/MadWifi

Try the ath_pci module but nothing.

I followed a second tutorial, this time from here - http://acx100.sourceforge.net/wiki/Distribution_list/Debian
It made the acx, modprobe acx then. Once again, nothing

Here goes the DMesg, i can't understand what's going on

Dmesg
----------
acx: this driver is still EXPERIMENTAL
acx: reading README file and/or Craig's HOWTO is recommended, visit http://acx100.sf.net in case of further questions/discussion
acx: compiled to use 32bit I/O access. I/O timing issues might occur, such as non-working firmware upload. Report them
running on a little-endian CPU
PCI module v0.3.35 initialized, waiting for cards to probe...
ACPI: PCI Interrupt 0000:07:01.0[A] -> GSI 22 (level, low) -> IRQ 82
acx: found ACX111-based wireless network card at 0000:07: 01.0, irq:82, phymem1:0x52024000, phymem2:0x52000000, mem1:0xf8aa4000, mem1_size:8192, mem2:0xf8ac0$initial debug setting is 0x000A
using IRQ 82
requesting firmware image 'tiacx111c16'
Real Time Clock Driver v1.12ac
acx: firmware image 'tiacx111c16' was not provided. Check your hotplug scripts
requesting firmware image 'tiacx111'
acx: firmware image 'tiacx111' was not provided. Check your hotplug scripts
acx: reset_dev() FAILED
ACPI: PCI interrupt for device 0000:07:01.0 disabled
acx_pci: probe of 0000:07:01.0 failed with error -5

lspci
-------
Network controller: Texas Instruments ACX 111 65Mbps Wireless Interface

iwconfig
------------
lo no wireless extensions.
eth1 no wireless extensions.
eth0 no wireless extensions.
sit0 no wireless extensions.

etc/modules
-----------------
loop
sbp2
wlan
acx
ath_hal
ath_pci

uname -r
----------
2.6.18-5-686

The acx was made by the first tutorial, and the ath_hal and the ath_pci were created by madwifi

I thank the help once again